标识桩是经常用于电力电缆铺设、通信光缆、燃气管道、农田水利、铁路、石油石化管线通道指示标志兼警告牌；也经常用于闹市、风景区、绿化带、灌木丛、顶管两侧管线路径指示起到警示作用，因此正确是埋设标识桩可使用更长时间，更好的警示作用。

The signpost is often used as an indicator and warning sign for power cable laying, communication optical cable, gas pipeline, farmland water conservancy, railway, petroleum and petrochemical pipeline channel; It is also often used in downtown areas, scenic spots, green belts, bushes, and pipeline route indication on both sides of pipe jacking to serve as a warning. Therefore, it is correct to bury marker piles to serve a longer time and better warning.

供水标识桩设置注意事项：

Precautions for water supply sign pile setting:

1、标识桩放置在管位上方，表面要求清洁、字迹清楚，如果不再管线上方，并说明平移距离。埋设在低于40cm绿化带中，长桩埋设在高于40cm绿化带或农田中。

1. The marking pile shall be placed above the pipe position, and the surface shall be clean and legible. If it is no longer above the pipeline, the translation distance shall be stated. Buried in the green belt less than 40cm, and the long pile is buried in the green belt or farmland more than 40cm.

2.标识桩一般间距为50m（纵向偏差≯0.15m），与管位中心线偏差≯0.25m。

2. Generally, the spacing of marker piles is 50m (longitudinal deviation ≯ 0.15 m), and the deviation from the centerline of the pipe position is ≯ 0.25 m.

3.在管道起点、终点、三通、转角处须设置标记管线走向方便辨别。

3. The starting point, end point, tee joint and corner of the pipeline must be marked with the pipeline route for easy identification.

4、标识桩上面的警示语和电话须朝马路放置或人经过时及时能看到的方位。

4. The warning words and telephone on the sign post must be placed towards the road or be visible when people pass by.

☆警示牌的设置和标识桩设置类似

☆ The setting of warning signs is similar to that of signposts

供水标识桩的编号规定

Numbering regulations for water supply marker piles

如果设计到采用编号方式的，有各个企业自己的编号方式或者一般情况下项目编号前6位数字加三位数顺序号组成。采用5cm高红色宋体字写于桩上。新建工程需在竣工图上注明桩位臵及编号，在竣工图左下角分别注明标识桩与标志牌总的数量。

If it is designed to adopt the numbering method, it is composed of the numbering method of each enterprise or the first six digits of the project number plus the three digit sequence number. It is written on the pile in 5cm high red Song typeface. For new projects, the pile location and number shall be indicated on the as built drawing, and the total number of identification piles and signboards shall be indicated on the lower left corner of the as built drawing.

管道设置要求

Pipeline setting requirements

当两根管道平行铺设且水平间距在0.4米1米时，除在每根管线上方相应标记牌或竖标记桩外，需在较短管线的标记牌或标记桩上标记字母“G,Z,D”.其中G代表管线为高压管线、Z代表管线为中压管线、D代表管线为低压管线。标记牌上字母高度为1cm，标识桩上字母写在桩编号下方，字母高度与桩编号高度相同。

When two pipelines are laid in parallel and the horizontal spacing is 0.4 m to 1 m, the letters "G, Z, D" shall be marked on the signboard or marker pile of the shorter pipeline, except for the corresponding signboard or vertical marker pile above each pipeline Where, G represents high pressure pipeline, Z represents medium pressure pipeline, and D represents low pressure pipeline. The letter height on the sign board is 1cm, and the letter on the marker pile is written below the pile number. The letter height is the same as the pile number.

供水标识桩间距及埋设注意事项就是上述所讲解的内容了，希望能够给您好的帮助，当然如果您有什么疑惑的话随时来我们网站http://www.binzhouhengtong.com进行咨询了解吧！

The spacing of water supply marker piles and the buried precautions are the contents explained above. I hope you can help me. Of course, if you have any questions, please come to our website at any time http://www.binzhouhengtong.com Consult and understand!